RESUMO
In this article, the optimization of printing properties on a new, flexible ceramic substrate is reported for sensing and antenna applications encompassing internet of things (IoT) devices. E-Strate® is a commercially available, non-rigid, thin ceramic substrate for implementing in room temperature and high-temperature devices. In this substrate, the printing parameters like drop spacing, number of printed layers, sintering temperature, and sintering time were varied to ensure an electrically conductive and repeatable pattern. The test patterns were printed using silver nanoparticle ink and a Dimatix 2831 inkjet printer. Electrical conductivity, high-temperature tolerance, bending, and adhesion were investigated on the printed samples. The three-factor factorial design analysis showed that the number of printed layers, sintering temperature, sintering time, and their interactions were significant factors affecting electrical conductivity. The optimum printing parameters for the thin E-Strate® substrate were found to be 20 µm drop spacing, three layers of printing, and 300 °C sintering temperature for 30 min. The high-temperature tolerance test indicated a stable pattern without any electrical degradation. Repetitive bending, adhesion test, and ASTM tape tests showed adequate mechanical stability of the pattern. These results will provide insight for investigators interested in fabricating new IoT devices.
RESUMO
PURPOSE: To reduce beam hardening artifacts caused by the shoulder joint, we explored new and unique methods to improve the quality of images, such as varying the injection site and changing the position of patients (swimmers position). MATERIALS AND METHODS: Fifth-four patients underwent neck CT examinations performed in routine and swimmers position and with a 64-slice MDCT scanner in spiral scanning. To examine the difference due to the injection sites of contrast material, subjects were divided into right- and left-side groups. For the evaluation of images, we carried out a subjective and objective assessment based on radiologists' ratings and noise measurement. RESULTS: Images of the lower neck in the swimmers position exhibited less hardening and streak artifacts. The subjective and objective evaluations showed that the swimmers position received higher rating by radiologists and had lower noise level than that of routine position. The swimmers position was the most effective for the diagnosis of the cervico-thoracic junction area. As for the injection site, we obtained better images by an injection of contrast material in the right arm than in the left. CONCLUSION: CT examination of the lower neck in the swimmers position may improve the quality of image and the effectiveness of diagnosis. The injection of a contrast material to the right side rather than the left side reduced foreign body artifacts.
